Important Points SOP (Standard Operating Procedure) During the Inspection of RCC NP4 Pipes

Image
Important Points SOP (Standard Operating Procedure) During the Inspection of RCC NP4 Pipes: -    Image-Hydro Test (Photo Credit: Ritesh Raj) (1.) Firstly, approved QAP will be checked.  (2.) ID marks should be marked on the inner and outer sides of pipes.  Image-ID Mark (Photo Credit: Ritesh Raj)  (3.) To check the inner and outer diameter of pipes.   (4.) Smooth finishing and before dispatch of RCC pipes cement slurry or grouting where required.   (5.) Load test is required for RCC pipes as per IS codes. It is different for each dia, of RCC pipes.  Image-Plate Load Test (Photo Credit: Ritesh Raj)   (6.) Concrete mix design checked and in which cement content, cement brand, and water-cement ratio should be checked.  (7.) The straightness test to be checked of RCC pipes through the straightness rods to collinear visible.   (8.) As per requirement 2% of hydro tests are to be checked as IS:458 of the total...

Important One Liner Question With Answers, Part 3


I am presenting here most important (mixed topic) one liner questions with their answer from civil engineering, in which most are asked in various competitive examinations. Please go through it. 



  (1.)  What % of agricultural land is reliably irrigated in India as per 2010 world bank data-35 %

        (2.)  In limiting value of Los angles abrasion value (in %) for wearing courses when these aggregates are to be used for concrete making-35 %

        (3.)  Local atmospheric pressure is measured using-Barometer

        (4.)  Rubber ballon method, Sand replacement method, Nulear density gauge is used- for measuring field compaction of soil

        (5.)  Castigliano’s method is not used for -measuring field compaction of soil

        (6.)  Which sleepers would be best for track circuiting-Wooden

        (7.)  The hydraulic grade line for a flow in pipe of fixed diameter is-Sloping downwards in the direction of flow

        (8.)  Which canal would the flow be practically uniform?-Wide Rectangular

        (9.)  The presence of intolerable levels of CO in the air impacts-Heart

       (10.) The application of chlorine beyond the stage of break-point is known as-Super-Chlorination


Image Source:-Pexels.com
       (11.) In a rectangular horizontal channel, for a hydraulic jump the ratio of depths after and before is 5. The jump can be classified as-Oscillating type

      (12.)One of the benefits of lining water canals for irrigation is that, it-helps increase the command area

      (13.)The area upstream of a dam must be suitable for requirements of-reservoir
   
      (14.) A phenomenon commonly observed in river sands for which adequate precautions need to be taken while estimating, measuring and receiving sands at constructions silts is-Bulking

      (15.)The specific gravity of municipal sewage is -Slightly greater than 1

      (16.) Which crops has longest base period in retard to irrigation-Sugarcane

      (17.) The sag correction applied during chaining is always-Negative

      (18.) The spring-cylinder analogy is used in soil mechanics to explain-Time dependent deformation of saturated clayey soils

      (19.) The gradient which determines the maximum loads that an engine can haul at a section is defined as- Ruling Gradient

      (20.)A soil can be considered as practically infertile when the PH reaches a value of-11


Image Source:-Pexels.com


      (21.)Which hydraulic jumps usually develops in barrages and canal head regulators-Weak and/or Oscillating type

      (22.)The hydraulic radius is defined as the radius of -Cross section area to wetted perimeter

      (23.) The method of growing crops on ridges running on the sides of water ditches used in certain agricultural fields is called as-Furrow irrigation

      (24.)  Which scale is used for estimating the hardness of stones-Moh’s
   
      (25.)  Which techniques is used for levelling across a river-Reciprocal levelling

      (26.)  The acceptable limit of portable water used in India for dissolved solids content (mg/l) is-500

      (27.) For road construction, in general sheep foot rollers are most suitable for-High plasticity clay
  
      (28.) If ‘d’ is the grain size, then the Lacey’s silt factor is proportional to-d0.5
    
      (29.)Which process take place during biological treatment of sewage effluents-Oxidation

      (30.) VG-30 grade of bitumen is suitable for 7 days average maximum air temperature (degree c) of-38 to 45
Image Source:-Pexels.com

Also Read :Important One Liner Questions with Answer,Part 2


      (31.) A direction theodolite -has only one vertical axis

      (32.) A rock formation which contains and readily yields water to tube wells is-Aquifer

      (33.) The resistance to gradual deformation by shear stress or tensile stress by a fluid is termed as-Viscosity

      (34.)Ghatghar (lower) dam is a type of-Roller compacted concrete dam

      (35.) In terms of the elements of curves, the angle through which forward tangent deflects is called as-Angle of deflevction

      (36.) The estimated value of a built-up property at the end of its useful life without being dismantled is its-Salvage value

      (37.) On a pressure-voids ratio plot for a soil, the slope of the linear portion is referred as -Compression index

     (38.) The measurement of longitudinal section survey is done on which basis-Linear

     (39.) If in a fluid, the shear stress is found to be directly proportional to the rate of angular deformation, then the fluid can be classified as-Newtonian

      (40.) The capacity of a single lane road is-inversely proportional to the average centre to centre spacing of the vehicles


Image Source:-Pexels.com


      (41.)While representing the energy equation, the difference between the total head line and the hydraulic grade line is -Velocity Head

      (42.)  Which curves can be used to avoid overturning of vehicles on a  curve-Transition

      (43.) For which consideration, slow sand filters are better than rapid sand filters used for water purification-Construction

      (44.)The process designed to suit the moisture content of timbers to the conditions and purposes for which it is to be used is called as-Conditioning

      (45.) What is the objective of having tie bars in rigid pavements-To firmly tie longitudinally adjacent slabs and prevent opening of joints

     (46.) In a contour map, closed contours with higher values inside represent-Hill


Image Source:-Pexels.com


     (47.)The operation of turning the telescope about its vertical axis in a horizontal plane is termed as-Swinging

     (48.) Measures the wind speed by-Anemometer

     (49.) The stone that exhibits highest compressive strength is-Gneisses

     (50.)   The base material for distemper is-Chalk

(51.)Broken bricks or stone chips are also called-Spall





Image Source:-Pexels.com






      
   Has this blog been helpful to you? If yes, please mention in the comment box.

   
      Thanks for visiting this site. 


Written By- 
Ritesh Raj
Email Id-rajritesh.motiharirr@gmail.com

Comments

Popular posts from this blog

"Sewer Network Analysis"

Important Points SOP (Standard Operating Procedure) During the Inspection of RCC NP4 Pipes

"Solar Power System"